FLASHER MODULE FOR LED OR INCANDESCENT LAMPS KEMO M206 9-48V 10A
Let's equalize the price. We guarantee the lowest price.
Tehnoshop is official distributor. Kemo electronic.
We ship worldwide. DHL, DPD, GLS...
Contact us for best shipping price.
Pick up point in Ljubljana. Contact us.
FLASHER MODULE FOR LED OR INCANDESCENT LAMPS
KEMO M206 4024028032061
You may connect either incandescent lamps or LED lamps with operating voltages ranging from 9 to 48 V/ DC to the flasher. The flasher is then operated at the operating voltage of the connected lamps. The device is short-circuit proof. Adjustable flash period: approx. 0.15 - 7 sec.
Technical data for Kemo M206:
- Operating voltage: 9 - 48 V direct-current voltage (depending on the connected lamps)
- Current-carrying capacity: max. 10 amperes (at 12 V these are e.g. lamps up to max. 120 W)
- Adjustable flash period: approx. 0.15 - 7 sec.
- Light-pause ratio: approx. 50/50%
- Own current consumption: Ø < 2.5 mA
- Dimensions of the module: approx. 87 x 60 x 33 mm
- Display at the module: flashing LED
- Connections: mounting tabs 6.3 mm
Assembly instructions: Connect the module with the current source (direct current, e.g. car battery) according to the drawing. The operating voltage may range from 9 to 48 V. The connected lamp must have the same electric tension as the operating voltage connected to the module. Example: When connecting a 12 V lamp, the connected operating voltage must be 12 V, too. The flasher should be mounted as close as possible to the connected lamp; the length of the supply line towards the lamp should not exceed 2 m. The length of the cable to the current source is optional. The flashing speed is adjusted with the trimmer next to the built-in LED using a small screwdriver. As control, the LED flashes at the same cycle as the connected lamp. Of course, it is also possible to connect several lamps in parallel. The total load of the connected lamps, however, should not exceed 10 A!
Setting into operation: When the device has been assembled and connected according the drawing, switch on the operating voltage. The connected lamps will then start flashing.
Intended use: Flasher for LED or incandescent lamps within the range of 9 to 48 V/DC, max. 10 A.
